Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Kensington?
Chimney liner installation in Kensington typically runs $1,800 to $4,500, and a partial or full chimney rebuild usually falls between $3,200 and $12,000 depending on how far the damage reaches. A stainless liner on a straightforward one-story flue sits at the low end; a full rebuild of a deteriorated stack on an older rowhouse in Kensington sits at the high end. These are typical estimates for the local market in 2026, and the written estimate we provide after inspecting your chimney sets the final price.
We handle the whole job under one roof: relining, resurfacing, crown and cap work, and structural rebuilds. From the top of the cap to the firebox floor, you’re dealing with the same crew from start to finish. Call (855) 974-3360 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Standard stainless liner install: $1,800 to $4,500 in Kensington.
- HeatShield resurfacing (no full reline): $1,200 to $3,000.
- Partial rebuild above the roofline: $3,200 to $7,500.
- Full rebuild from the ground up: $7,500 to $12,000 or more.
- Crown rebuild and cap: $400 to $1,500 combined, the cheapest way to stop water damage before it spreads.
- Estimates are free, and the price is set per job by the written estimate.
Chimney Liner & Rebuild Cost Breakdown (2026)
Here’s how the line items stack up for the Kensington market. Every chimney is different, so treat these as typical ranges, not quotes. The written estimate you receive after inspection is what you pay.
| Work Item | Typical Range (Kensington, 2026) |
|---|---|
| Stainless steel liner (single flue, one story) | $1,800 – $3,500 |
| Stainless steel liner (two-story, or with offsets) | $3,200 – $4,500 |
| Insulated liner upgrade | adds $400 – $900 |
| HeatShield resurfacing (no full reline) | $1,200 – $3,000 |
| Partial rebuild (above roofline) | $3,200 – $7,500 |
| Full rebuild (ground to cap) | $7,500 – $12,000+ |
| Crown rebuild | $400 – $1,200 |
| Chimney cap (stainless) | $200 – $600 |
| Waterproofing application | $250 – $650 |
| Firebox / damper repair (add-on) | $350 – $1,500 |
What pushes the number up or down? The big ones are access and condition. A Kensington rowhouse with the chimney tight against a neighboring wall is harder to reach than a freestanding stack, so scaffolding or a lift can add cost. If the flue has offsets or an irregular shape, the liner has to be custom-fitted rather than pulled straight down. On the rebuild side, the difference between a partial and a full rebuild is usually whether the damage has reached the smoke chamber and the section below the roofline. We use Gelco and Copperfield crowns, DuraFlex liner systems, HeatShield resurfacing, and Olympia Chimney and Famco components because those are the materials specified by certified chimney professionals for the conditions in this region. Built to last, not patched to pass inspection.
What Affects Chimney Liner & Rebuild Pricing in Kensington
- Chimney height and flue count. A taller stack needs more liner material and more labor. A single-story flue on a small Kensington home is the cheapest scenario; a multi-flue chimney with a furnace and a fireplace venting separately costs noticeably more.
- Roofline access on a rowhouse. Much of Kensington is built up with adjoining rowhouses, which means the chimney often sits against a party wall with no easy ladder access. That can mean scaffolding or a lift, and that labor is part of your estimate.
- Existing damage and debris. A chimney with heavy creosote buildup, cracked tiles, or a blocked flue needs cleaning and inspection before any liner goes in. If the flue is badly deteriorated, we may recommend HeatShield resurfacing first to stabilize it before relining.
- Liner material and insulation. Stainless is the standard for its durability and heat resistance. An insulated liner upgrade adds cost but is often the right call for a chimney that vents a wood stove or an older gas appliance, because it improves draft and reduces condensation in the flue.
- Rebuild scope. A crown-and-cap repair is a small job. A partial rebuild above the roofline fixes the visible top of the stack. A full rebuild is what happens when the mortar joints have failed below the roofline and the chimney is no longer structurally sound.
- Code compliance. If your chimney doesn’t meet current codes, part of the cost goes to bringing it into compliance. We reference NFPA 211 and local code requirements as the baseline, not as an upsell. Most cities require a permit for structural chimney work, so ask your city’s building department what applies to your address.
There’s a local angle worth knowing about. The older housing stock across Kensington means many chimneys were built before modern liner standards, and some were originally lined for coal or for an open fireplace only. When a homeowner switches to a wood insert or a high-efficiency gas appliance, the original flue is often undersized for the new venting load. That’s the most common reason we end up recommending a full reline rather than a simple cleaning, and it’s why we start with a real inspection instead of quoting a number off a chart. If you want to go deeper on how relining and rebuilds work together, see our chimney liner & rebuild page.
How to Save on Chimney Liner & Rebuild
Chimney work isn’t the place to chase the cheapest quote, but there are smart ways to keep the bill from climbing.
- Catch water damage early. A cap and crown rebuild in the $400 to $1,500 range prevents the water intrusion that turns a small repair into a full rebuild. The crown is the most common source of water damage on a Kensington chimney, and it’s the cheapest fix on this page.
- Fix the crown before it spreads. If your crown is cracked, get it repaired now. Water that gets into a cracked crown travels down the masonry, freezes in winter, and loosens mortar joints. That’s how a $900 crown job becomes a $6,000 rebuild.
- Big jobs only cost more later. We don’t sell maintenance plans or schedule upsells, but we do tell you plainly when a problem is small enough to watch and when it isn’t. A free estimate means you find out before you commit.
- Ask whether resurfacing will do the job. Not every chimney needs a full reline. Sometimes a HeatShield resurfacing solves the problem at a fraction of the cost. We’ll tell you which applies to your chimney’s actual condition, not a one-size-fits-all upsell.
- Get the whole system inspected, not just the flue. A free estimate from Chimney Sweep Kensington covers the full system, from the firebox to the crown, so you know the total scope before the work starts. Call (855) 974-3360 to book one.
Can You Fix a Chimney Liner the Same Day?
Liner installation usually takes a full day or more, and it depends on the chimney’s height and whether the flue needs prep work first. A straightforward single-flue stainless liner on an accessible Kensington chimney can sometimes be completed in one visit, while a two-story flue or a chimney with offsets or heavy creosote may need a second day. We schedule the inspection first, then give you a realistic timeline in the written estimate. Call (855) 974-3360 for a same-day estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Is It Cheaper to Repair or Replace a Chimney Liner?
Repair is cheaper when the problem is limited to the top of the flue or the crown, and it costs less to repair a chimney in the $400 to $1,500 range than to replace a liner at $1,800 to $4,500. The decision comes down to the condition of the flue. If the original clay tiles are cracked, spalled, or offset, patching won’t hold, and a full reline is the more durable choice. If the damage is surface-level, resurfacing can extend the life of the chimney considerably. We’ll tell you which one your chimney actually needs.
Why choose Chimney Sweep Kensington?
We’re a full-system chimney specialist, not a sweep-only shop. That means we can handle the liner and the rebuild without handing you off to another contractor halfway through the job. Our roster of professional-grade brands includes DuraFlex and HeatShield liner systems, Gelco and Copperfield crowns, and Olympia Chimney and Famco components, so we specify the right material for your chimney’s condition. Our technicians have up to 9 years of experience, and we present clear, upfront pricing after inspection. You get one crew for every layer of your chimney system.
FAQs – Chimney Liner & Rebuild Cost
How much does chimney liner installation cost in Kensington?
It usually runs $1,800 to $4,500 for a stainless steel liner, depending on chimney height and flue layout. A single-flue, one-story install sits near $1,800, while a taller flue or one with offsets climbs toward $4,500. Call (855) 974-3360 for an exact quote. Estimates are free.
How much does a chimney rebuild cost in Kensington?
A partial rebuild above the roofline typically costs $3,200 to $7,500, and a full rebuild from the ground up can reach $7,500 to $12,000 or more. The biggest cost driver is whether the damage has reached below the roofline. Call (855) 974-3360 for a free estimate.
Can you fix a cracked chimney crown the same day?
A crown rebuild is often a single-day job and typically costs $400 to $1,200. A stainless cap adds $200 to $600 if you don’t have one. Call (855) 974-3360 to schedule. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What’s the difference between a liner repair and a full reline?
A repair is a limited fix, usually $350 to $1,500, while a full reline is $1,800 to $4,500. Repairs make sense when the flue is structurally sound; a reline is the right call when the original tiles are cracked or offset. Call (855) 974-3360 and we’ll tell you which your chimney needs.
Does chimney work require a permit in Kensington?
Most cities require a permit for structural chimney work such as a rebuild, so ask your city’s building department what applies to your address. Liner work may also fall under local code, and we work to NFPA 211 standards. Call (855) 974-3360 to talk through your project. Estimates are free.
Get a Free Chimney Liner & Rebuild Estimate in Kensington
A chimney liner or a rebuild isn’t a small purchase, and you deserve a real number before any work begins. Chimney Sweep Kensington offers free estimates for the full job, from sweeping and inspection through liner installation, crown and cap work, and full rebuilds. We specify professional-grade materials because your chimney vents fire, and what’s inside it matters. Whether you need a simple liner replacement or a full rebuild, we’ll walk you through the scope and give you an upfront price in writing. Call (855) 974-3360. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. For more on our full range of services, visit chimney sweep Kensington.
Pricing reflects the Kensington market as of 2026. Chimney Sweep Kensington offers free estimates – call (855) 974-3360.
Written by the team at Chimney Sweep Kensington.
What Our Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
- Bryce Thompson"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Mark Gallagher"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Tim Pruitt