Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Cap & Crown Cost in Kensington?
Chimney cap and crown work in Kensington typically runs from $260 to $420 for a standard stainless cap installed on a sound flue, and $700 to $1,600 for a crown rebuild with the cap included. If the crown has cracked and water has been getting behind it, most homeowners end up in the $950 to $1,800 range once mortar repair and waterproofing are added. We give a written estimate before any work starts, so the number you agree to is the number you pay.
A cap keeps rain, birds and squirrels out of the flue. A crown keeps water off the masonry itself, and it’s the part most people forget about until a crack opens up. Kensington sits on higher ground with older brick rowhouses and detached homes built across several decades, and the freeze-thaw we get from December through March works on masonry shoulders harder than anything else. A crowning mix that was skimped on shows it fast here. Below is what the work actually costs, what moves the price up or down, and how to spot the difference between a repair worth doing and a rebuild you don’t need yet.
Key Takeaways
- A standard chimney cap installed in Kensington: roughly $260 to $420.
- A custom cap for an oversized or odd-shaped flue: $400 to $750.
- Full crown rebuild with mortar repair and cap: $700 to $1,600.
- Water damage behind a failed crown is the leading reason cap and crown costs climb.
- Free estimates, and the written quote sets the final price.
Chimney Cap & Crown Cost Breakdown (2026)
These ranges are typical for the Kensington market in 2026. Every chimney is different, so treat these as a starting point and let the written estimate on your specific flue set the final figure.
| Line Item | Typical Estimate |
|---|---|
| Standard stainless steel cap (single flue, stock size) | $260 – $420 |
| Custom-fit cap (oversized flue, multi-flue, or non-standard shape) | $400 – $750 |
| Copper cap | $600 – $1,100 |
| Cap removal and re-installation (for sweeping beneath) | $90 – $180 |
| Crown repair – patching hairline cracks with crown coat | $340 – $650 |
| Full crown rebuild (old crown removed, new mortar crown formed) | $700 – $1,600 |
| Waterproofing applied to the exterior masonry | $200 – $450 |
| Crown rebuild with cap and waterproofing combined | $950 – $1,800 |
| Flashing repair where the crown meets the masonry (when needed) | $180 – $400 |
What drives the price up most often is what’s happening underneath. A sound crown with a straight flue is a straightforward job. A crown that has been letting water in for a few seasons, with soft mortar behind it and a rusted-out damper box below, turns into masonry repair and a longer day. What drives it down is catching it early: a hairline crack patched before winter costs a fraction of a rebuild, and a cap installed on a healthy chimney is the cheapest insurance in the trade. We specify professional-grade materials because your chimney vents fire, and the cap and crown are the first line of defense against water getting into the venting system itself. When the crown job sits alongside interior work, we handle the full system from chimney cap & crown work down to the firebox so there’s no handoff to a second contractor.
What Affects Chimney Cap & Crown Pricing in Kensington
Two chimneys on the same block can come in $600 apart. Here’s what actually moves the number.
- Flue shape and size. A standard round or square flue takes a stock cap. An oversized flue, an oval tile, or a chimney with two flues under one crown needs a custom cap, and that pushes the job into the $400 to $750 range on cap alone.
- Crown condition and what’s underneath. If the crown is still mostly intact with surface cracks, we can patch and seal it. If the mortar has softened and the crown is separating from the flue tile, it has to come off and be rebuilt. That’s the biggest single swing in the estimate.
- Masonry type and age of the brick. Older Kensington homes often have brick that has absorbed water for decades. Soft or spalling brick means extra prep before new mortar will bond, and sometimes a repair that reaches below the crown into the top courses.
- Freeze-thaw exposure. Our winters swing above and below freezing repeatedly, which works on any crack in the crown. Crowns that were mixed thin or sloped the wrong way show the damage first, and homes on the higher, more exposed lots feel it more. Repairs made in spring last longer than repairs rushed in late fall.
- Access and roofline. A steep roof or a chimney set back from the ridge takes longer to work on safely. That labor is part of the estimate, not a surprise added later.
- Add-ons that make sense while we’re up there. Waterproofing on the exterior masonry, a new flue tile if the top one is cracked, or flashing repair at the roofline. Bundling these into one visit usually costs less than doing them separately, and we’ll tell you which ones can wait.
Cap and Crown: What You’re Actually Paying For
A cap is the metal lid and mesh that sits on top of the flue. It does two jobs: it deflects rain and snow out of the flue, and its spark screen keeps birds, squirrels and debris from nesting inside. Most caps are stainless steel. Copper caps cost more and weather to a dull brown over time, which some homeowners prefer for the look.
A crown is the concrete or mortar crown at the top of the masonry, sloped so water runs off the sides of the chimney instead of down into it. When a crown cracks, water gets behind it, freezes, expands and widens the crack. Over a few winters this is how a simple repair turns into a rebuild, and how water reaches the flue tile, the damper and eventually the firebox. That’s why the crown isn’t cosmetic. It’s the roof of your chimney.
This is also why we treat cap and crown work as part of the whole system, not a standalone job. If the crown needs rebuilding, we’re looking down the flue to see whether the liner is intact. If water has already gotten in, we’re checking the damper and firebox. One crew, every layer of your chimney system means the crown doesn’t get fixed while a separate contractor later tells you the liner is shot. We handle sweeping, cap and crown, liner installation, full rebuilds and fireplace repair under one company.
How to Save on Chimney Cap & Crown in Kensington
The biggest savings come from timing. A crack that gets patched before the first hard freeze costs less than a crown that has to be rebuilt in the spring. Some practical ways to keep the cost down:
- Get the cap on before the crown fails. A cap keeps water off the flue and out of the crown edges. It’s the cheaper half of the job, and doing it early is how you avoid the rebuild.
- Repair the crown, don’t replace it, when the crown allows it. If the crown is sound at its base with only surface cracking, a crown coat repair runs $340 to $650 and buys years of service. We’ll tell you honestly which side of that line your crown is on.
- Bundle waterproofing with the crown work. Doing the exterior waterproofing while we’re already set up on the roof usually costs less than a separate trip.
- Ask whether the cap can be re-installed. If you’re having the chimney swept and the existing cap is in good shape, removing and re-installing it is a modest charge, not a new cap.
- Get a written estimate before work starts. This is free, and it’s the single best protection against a price that creeps up mid-job. Call (855) 974-3360 for a free estimate.
Is It Cheaper to Repair or Replace a Chimney Crown?
Repair is cheaper when the crown has surface cracks or minor crumbling, usually $340 to $650, while a full rebuild runs $700 to $1,600. The deciding factor is whether the crown is still bonded to the flue tile and whether the mortar underneath has softened. If the crown is lifting away from the flue or the masonry beneath it is soft, patching only hides the problem for a season or two. We look at the base of the crown, the flue tile at the top, and the brick just below before recommending either path. Call (855) 974-3360 and we’ll walk you through what we see. The estimate is free.
Do I Need a Cap and Crown, or Just One?
Most homeowners need both, and the cost combined is $950 to $1,800 when the crown has failed. A cap without a sound crown leaves water soaking into the masonry from the top edges. A crown without a cap leaves the flue open to rain, snow and animals. Think of it this way: the cap protects the flue, the crown protects the masonry. Together they cover the top of the chimney. If your crown is sound and you only have an open flue, a cap alone at $260 to $420 is a sensible starting point.
Can You Match a Cap to My Chimney’s Shape?
Yes. Non-standard flues get a custom-fit cap, typically $400 to $750, formed to the exact dimensions of the flue opening. Oval tiles, oversize square flues, and chimneys with multiple flues under one crown are common in Kensington’s older housing stock, and a stock cap that doesn’t seal properly lets water and animals in anyway. We measure the flue and specify a cap that fits it, not the nearest size on a shelf.
How Long Does Cap and Crown Work Take?
A standard cap install takes under two hours. A crown rebuild usually takes a full day, and sometimes a second visit is needed to finish the mortar slope and apply waterproofing once it’s set. Cold or wet weather can push the mortar work, which is one more reason spring and early summer are good months for crown repairs in Kensington. Call (855) 974-3360 and we’ll give you a realistic timeline for your chimney.
Will a Cap and Crown Stop Water Damage?
In most cases, yes. A properly fitted cap and a sound, correctly sloped crown are the two things that keep water out of the top of a chimney, and water intrusion is the leading cause of chimney deterioration. What a cap and crown can’t fix is damage already done below: a cracked flue tile, a rusted damper, or masonry that’s already absorbed water. That’s where a full chimney assessment matters. We check the flue and the firebox while we’re there, so you know whether the top-of-chimney work is the whole repair or just the first step.
What Are the Warning Signs You Need Crown Repair in Kensington?
Look for cracks in the crown visible from the ground with binoculars, a white chalky stain on the outside of the chimney, crumbling mortar between bricks near the top, or water stains on the ceiling near the chimney chase inside the house. Any of these point to water getting in. Don’t go up on the roof to check yourself. Roof work on a steep pitch is genuinely dangerous, and the crown is best inspected by a trained professional with the right access and safety gear. If you see the signs from the ground, call (855) 974-3360.
What Makes a Cap and Crown Job Last in Kensington?
Three things: the right material, a proper slope, and a waterproof coating on the masonry. We use professional-grade brands including DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco and Copperfield, the same materials certified chimney professionals specify nationwide. Our technicians have up to 9 years of experience, and our approach if the crown needs rebuilding is to build it to last, not to patch it to pass an inspection. If the crown job uncovers a liner problem, we can address it in the same project, and if the flue needs relining, HeatShield resurfacing or a DuraFlex liner system gives us options based on your chimney’s condition. That matters because it means one crew, one estimate and no handoff to someone else.
Serving homeowners across the area from Chimney Sweep Kensington, we handle the full chimney system from the top of the cap to the firebox floor. If you’re ready to get a real number for your chimney, call us. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
FAQs – Chimney Cap & Crown Cost
How much does a chimney cap cost in Kensington?
A standard stainless steel cap installed in Kensington runs $260 to $420, while a custom-fit cap for an oversize or non-standard flue runs $400 to $750. Copper caps run $600 to $1,100. Call (855) 974-3360 for an exact quote; estimates are free.
How much does a chimney crown rebuild cost in Kensington?
A full crown rebuild in Kensington typically costs $700 to $1,600, and with a cap and waterproofing added the job usually lands between $950 and $1,800. A crown coat repair for surface cracks runs $340 to $650. Call (855) 974-3360 and we’ll tell you which you actually need.
Is it cheaper to repair or replace a chimney crown?
Repair is cheaper at $340 to $650 when the crown has surface cracks and is still bonded to the flue. A rebuild at $700 to $1,600 is the right call when the crown is separating or the mortar underneath has softened. Call (855) 974-3360 for a free look before you decide.
Can you come out today for a cap and crown estimate?
Same-day estimates are often possible. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. We’re closed Saturday, so a call on Saturday gets booked into the next opening. Call (855) 974-3360 for a free estimate.
Why does my chimney crown keep cracking?
Crowns crack because of freeze-thaw movement, a crown that was mixed thin, or a slope that lets water pool instead of run off. In Kensington’s winters, a thin crown can crack within a season or two. A rebuild with the correct mix and slope, plus a cap and waterproofing at $950 to $1,800 combined, is the durable fix. Call (855) 974-3360 to get it assessed.
Do I really need a cap on my chimney?
Yes, in almost every case. An open flue lets rain and snow straight in and invites birds and squirrels to nest, and a cap at $260 to $420 is far less expensive than repairing the water damage and blockages that follow. Call (855) 974-3360 and we’ll size one for your flue.
Pricing reflects the Kensington market as of 2026. Chimney Sweep Kensington offers free estimates – call (855) 974-3360.
Written by the team at Chimney Sweep Kensington.
What Our Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
- Bryce Thompson"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Mark Gallagher"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Tim Pruitt