Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Liner & Rebuild Across Kensington
Kensington chimneys are a different job from what you’ll find in most of the country. They’re rowhouse stacks: shared, hidden behind later facades, and often still carrying the coal-era flues they were built with more than a century ago. We work on these chimneys constantly, and that changes how a liner or rebuild gets planned, from how we get onto the roof to how we keep one flue’s exhaust out of the one next door. If your appliance is drafting poorly or you’ve smelled a neighbor’s heat in your living room, call (855) 974-3360. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. Estimates are free, and the written estimate sets the final price.
Why Kensington Homeowners Call Chimney Sweep Kensington for Chimney Liner & Rebuild
We know what a Kensington block looks like from the roof. On a lot of these streets the attached rowhouses are so close together that a technician can set one ladder and reach across three or four chimneys in the same run, and longtime residents often know exactly which houses still have abandoned coal chutes and unlined flues nobody ever updated. That local knowledge matters, because a liner job here isn’t just “install stainless in a flue.” It’s figuring out which flue your appliance actually owns, how it shares the stack with the house next door, and where water from a cracked crown is getting into a masonry section that’s been sitting behind a rehabbed facade for decades.
We serve Kensington and build liner and rebuild work off what we find on camera, not what looks bad from the sidewalk. Every job starts with a Level 2 inspection, and the photo report goes to you before any work gets priced. Our technicians have up to 9 years of experience, and the local pro we connect you with is licensed and insured as their state requires.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Liner & Rebuild Services in Kensington
Most of the liner and rebuild work we handle in Kensington’s rowhouses comes down to four things: getting the right stainless system into a flue that wasn’t built for modern venting, replacing a liner that’s already failed, or rebuilding the masonry that holds the whole stack together. Here’s how each one usually goes.
Stainless Steel Liner
A stainless steel liner gives a heating appliance its own sealed path from the firebox or appliance collar up to the top of the stack, which is exactly what a shared Kensington rowhouse chimney usually lacks. We size the liner to the appliance and insulate it where the flue runs against an adjacent one, so exhaust doesn’t migrate sideways at the smoke chamber. Gelco and Olympia Chimney components are the usual spec on these installs.
Flexible Liner
Flexible liner is what makes relining a coal-era flue possible without demolishing masonry. These chimneys were built square or roughly rectangular, with offsets and mortar joints that a rigid pipe won’t follow. A flexible liner threads through the original flue and gives your appliance a continuous path, even on a Kensington block where the stack has been patched and reworked several times over the years.
Liner Replacement
When an existing liner has failed, we pull the camera through first to see where the gap, collapse, or heavy creosote actually is. Replacement is common in Kensington homes that were converted from coal to gas or oil and never had the original unlined flue brought up to a modern standard. The new liner gets sized, insulated, and capped as one job so the whole system works as a single vent.
Partial Rebuild
A partial rebuild targets the damaged section of masonry, usually the top several courses where freeze-thaw winters and humid summers have spalled brick and cracked the crown. On attached rowhouses we’re working on a narrow footprint with neighbor chimneys right beside us, so the rebuild gets planned around roof access and drainage, not just the masonry itself. Cap and crown work is included because water intrusion is what caused most of the damage in the first place.
For full rebuilds and everything else, our chimney liner & rebuild page covers the full scope.
Trusted Brands We Service in Kensington
We specify DuraFlex, HeatShield, Gelco, Olympia Chimney, and Famco because those are the materials certified chimney professionals actually install, and we don’t hand you a brand list and disappear. If your Kensington rowhouse has a HeatShield resurfacing job already on file, or a DuraFlex liner that’s due for inspection, we work with those same systems. No parts stocked on a truck, no guessing on the rooftop: we order the right components for your flue’s dimensions and install them to spec. Famco and Copperfield caps and components are also part of the standard kit for closing a chimney off properly. The turnaround is built around your heating schedule, not ours.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Liner & Rebuild Problems We See in Kensington Homes
- Shared-stack cross-contamination. In a Kensington rowhouse, your neighbor’s appliance can vent into the same continuous stack, and a failed liner lets exhaust cross into your flue at the smoke chamber. That’s the most serious liner problem we see here, and it’s why the camera inspection matters so much.
- Unlined coal-era flues behind rehabbed facades. Many of these chimneys were originally built for coal and later converted to gas or oil, and often the original flue was never updated. Spalling mortar and a cracked crown then let water into the stack, and it goes unnoticed until the lining is already compromised.
- Rooftop access across attached rowhouses. When the roofline is continuous for a whole block, caps and flashing get knocked or skipped, and a brush or camera run from the wrong setup can cross into a flue that isn’t yours. Planning access is half the job.
- Freeze-thaw damage at the crown. Philadelphia’s winters cycle masonry through freeze and thaw, which cracks crowns and opens joints on exposed rowhouse chimneys. Once that happens, water gets behind the liner and the masonry starts to fail from the inside.
Pricing for Chimney Liner & Rebuild in Kensington, PA
Liner and rebuild pricing in Kensington runs higher than what you’d see on detached housing in the suburbs, mostly because of access. A flexible liner install on a typical Kensington rowhouse usually runs $2,200 to $4,800, while a full stainless steel liner with insulation and a proper cap lands in the $3,500 to $6,500 range. Liner replacement on an existing flue runs $1,800 to $4,200. A partial rebuild at the top of the stack usually comes in at $1,500 to $4,500, and a full chimney rebuild runs $7,000 and up depending on how much masonry is involved. What moves the number is flue length, whether the flue is offset, how much of the original stack is accessible from the roof, and how much hidden damage shows up on camera. The estimate is free, and the written estimate sets the final price. Call (855) 974-3360.
We Also Serve Cities Near Kensington
We handle the same rowhouse liner and rebuild work in Port Richmond, Fishtown, Frankford, and Hunting Park, where the housing stock and shared-chimney problems are very similar. The access challenges change block to block, but the approach stays the same: inspect first, show you the camera evidence, then price the work.
Serving Kensington, PA – Our Local Coverage Area
We serve Kensington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Liner & Rebuild in Kensington
Yes, it can, and that’s why shared-stack liner work here gets handled carefully. Your flue and theirs may run side by side in the same masonry structure, so installing a new sealed liner on your side doesn’t change their appliance venting as long as the flues are properly separated at the smoke chamber and top. The risk comes when a flue has a gap and exhaust crosses over. We inspect both sides where access allows and tell you plainly if the shared stack needs attention on the neighbor’s side too. Call (855) 974-3360 for an exact quote; estimates are free.
Most of the time a liner is the answer, not a full rebuild. An unlined coal-era flue can usually be relined in stainless as long as the surrounding masonry is still sound, and the camera inspection tells us whether it is. A rebuild only becomes necessary when the masonry itself has failed, such as spalled courses or a cracked crown that lets water into the stack. Estimating this over the phone isn’t possible, but the camera will show you exactly what we see. Call (855) 974-3360 for an exact quote; estimates are free.
We reach it from a ladder set up on the roof or rear access point, and on attached rowhouses we plan the setup around the neighboring rooftops. That means choosing the right spot to set the ladder and the right angle to run the brush or camera, since one wrong setup can put the camera into the neighbor’s flue. Our technicians have up to 9 years of experience with exactly this kind of access. Call (855) 974-3360 for an exact quote; estimates are free.
Third-degree creosote is a glazed, hardened layer that has baked onto the flue walls, and it can’t be brushed away the way lighter creosote can. On an older Kensington rowhouse, that often means the liner has to come out or be replaced rather than cleaned, because the glazed layer indicates the flue has been running too cool or too restricted. It’s the single most common reason a liner job here turns into a replacement. Call (855) 974-3360 for an exact quote; estimates are free.
It drafts poorly because a rehab can change how the house moves air, and because the chimney’s interior condition doesn’t show from the street. New windows, new insulation, and a sealed-up structure all reduce the air a stove or fireplace needs to pull a proper draft, and a shared rowhouse flue with a gap or missing liner makes it worse. The camera inspection shows whether it’s an air-supply issue or a flue problem. Call (855) 974-3360 for an exact quote; estimates are free.
If you’ve got a Kensington rowhouse with a liner that needs work, or a stack that’s been quietly failing behind a facade for years, we’d rather look at it before it turns into masonry work. Call (855) 974-3360 for a free estimate. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. We’re closed Saturday.
Written by the team at Chimney Sweep Kensington.