Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Repair for Kensington Homeowners
Chimney repair in Kensington usually starts with a small problem you can see from the sidewalk: a crumbling mortar joint, a loose cap, or a stain that appears on the ceiling after a heavy rain. Left alone, each of those turns into a bigger and more expensive repair, because water gets in and freezes, and the freeze-thaw cycle our winters bring does the rest. Our technicians have up to 9 years of experience handling mortar, brick, liners and flashing on Kensington chimneys, and we can inspect and quote the same day in most cases. Call (855) 974-3360 to get a free written estimate before anything is booked. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What Our Chimney Repair Service Includes
Repair work on a chimney is layered. The crown at the top, the brick and mortar in between, the flashing where the chimney meets the roof, and the liner inside all fail for different reasons and get fixed with different materials. We handle every one of those layers, so you aren’t calling a roofer for flashing and a mason for brick and a sweep for the liner. One team, one job, one written estimate.
Mortar Repointing
Repointing is grinding out the old, crumbly mortar between the bricks and packing in fresh mortar that bonds to the masonry properly. You need it when the joints have receded or turned sandy, which lets water sit in the gaps and freeze. We match the mortar mix to the brick so the repair doesn’t trap moisture or crack the face of the brick later.

Spalling Brick Repair
Spalling is when the face of a brick flakes off or pops away, usually after water soaks in and freezes behind it. It shows up as rough, pitted brick and piles of flakes on the roof or ground below the chimney. We replace the damaged bricks with matched units and correct whatever is letting water in behind them, since swapping brick without fixing the source just delays the same failure.

Chimney Waterproofing
Waterproofing is a breathable sealer applied to the masonry so rain beads off instead of soaking in. It’s the right call for a chimney that’s structurally sound but takes on water every season, and it’s worth doing after repointing or a rebuild. We use a vapor-permeable product so moisture inside the chimney can still escape, which matters in a climate with real freeze-thaw cycles like ours.

Flashing Repair
Flashing is the metal where the chimney passes through the roof, and it’s one of the most common sources of leaks that homeowners blame on the chimney itself. You need it checked when water stains show up on the ceiling or the attic near the chimney. We reset or replace the flashing and seal the joints against the masonry and the shingles, which is often the whole fix.
Chimney Rebuilding
A rebuild is for a chimney where the damage has gone past repointing, typically the top few courses of brick above the roofline. It means tearing down the failed section and rebuilding it with new brick and mortar, usually matching the rest of the house. We rebuild from the crown down to sound masonry only, rather than patching over brick that’s already lost its structure.
Tuckpointing
Tuckpointing is a finer form of mortar repair where the joint is finished with a shaped, slightly contrasting mortar for a cleaner look on visible chimneys. It’s chosen when the masonry is sound but the joints look worn or uneven from the street. The structural prep is the same as repointing; the difference is the finish and the care taken with the joint profile.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Repair
Most of the repair work we do ends up involving a liner or a resurfacing system, and the material matters as much as the labor. We install HeatShield for chimneys where the existing flue is sound enough to be resurfaced from the inside rather than torn out and relined. HeatShield lets us restore the flue without opening up walls, and we size the application to the actual flue condition we see on camera. We also work with DuraFlex stainless liners when the flue is too far gone for resurfacing and needs a full relining, which happens more often on older Kensington chimneys that have been through decades of heating cycles.
On the masonry side we work with materials from Famco and Copperfield for caps, crowns and related components, matched to the chimney rather than picked off a shelf. Whether your chimney has a HeatShield-resurfaced flue, a DuraFlex liner, Famco or Copperfield components, or any other make, we can help. We specify professional-grade materials because your chimney vents fire, and a repair that fails quietly is worse than no repair at all.
Signs You Need Chimney Repair Right Now
- Crumbling or sandy mortar joints. If you can scrape mortar out with a screwdriver, it’s already failing. That means water is getting into the joints and freezing, and the damage spreads with every cold snap.
- Flaking brick or debris on the roof. Brick faces that pop off leave the softer inner material exposed, which absorbs water fast. Catching this early usually means repointing and a few brick replacements instead of a rebuild.
- Water stains on the ceiling or attic near the chimney. Stains after rain almost always point to flashing or a failed crown, not the roof itself. Finding the source early stops the rot and the interior repair bill.
- A cracked or crumbling crown at the top. The crown sheds water away from the chimney, and once it cracks, water runs down into the masonry. A crown repair is small money compared to the rebuild it prevents.
- A loose or missing cap. Without a cap, rain, birds and debris go straight down the flue. A cap and crown repair is one of the cheapest fixes on the list and one of the most protective.
If you’re seeing more than one of these, it’s worth having the whole chimney looked at rather than patching one spot. Our chimney sweep in Kensington visit includes a camera inspection of the flue at the same time, so you get the full picture in one appointment.
Our Chimney Repair Process – Step by Step
- 1
Inspection and camera scan. We look at the chimney from the roof, the ground and inside the firebox, and run a camera down the flue to see the liner condition. You get photos of what we find, not just a verbal description.
- 2
Written estimate with the options laid out. We tell you what’s failing, what can wait, and what the repair will cost. Where resurfacing will work, we quote HeatShield; where it won’t, we quote a DuraFlex reline. No one-size-fits-all upsell.
- 3
Sweep and prep before any repair. Mortar and brick work on a dirty flue makes a mess and hides problems. We clean the flue first so the repair is done on a clean surface and the camera can see the results.
- 4
The repair itself. Repointing, tuckpointing, brick replacement, flashing reset, crown and cap work, or a partial rebuild, done with matched mortar and components from Famco or Copperfield. Nothing gets patched to pass an inspection and fail next winter.
- 5
Final check and photo report. We re-scan the flue, check the repair, and leave you with the photos and a clear note on what we did and what to watch. If something can safely wait, we tell you that too.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Repair Cost in Kensington?
Most chimney repairs in Kensington fall between $250 and $3,500 depending on how much of the chimney is involved and whether the flue needs work too. The written estimate sets the final price, and the estimate itself is free.
| Repair type | Typical estimated range |
|---|---|
| Mortar repointing (partial) | $250 – $700 |
| Spalling brick repair (spot replacement) | $300 – $900 |
| Chimney waterproofing | $300 – $650 |
| Flashing repair or reset | $350 – $800 |
| Crown and cap repair | $350 – $900 |
| Partial chimney rebuild (above roofline) | $1,800 – $3,500 |
| HeatShield resurfacing or DuraFlex reline | $1,500 – $4,500 |
What drives the number is how high the chimney is, how much brick has to come out, whether access from the roof is straightforward, and whether the liner is involved. The way to avoid overpaying is to insist on camera evidence before any liner or rebuild work is approved: if a contractor tells you the flue is shot, ask to see the scan. We show you ours. Nothing is recommended without camera evidence you can look at yourself, and we say plainly when a repair can safely wait until next season. The estimate includes the inspection, the photos and the full price breakdown, with no service-call fee. Call (855) 974-3360 for an exact quote, and we’ll book a chimney repair visit at a time that works for you.
Chimney Repair Near Kensington – Our Service Area
We connect homeowners with local chimney professionals across Kensington and the neighborhoods around it, including Port Richmond, Fishtown, chimney repair in Southwest Philadelphia, Eastwick, and out toward chimney repair in East Lansdowne, Upper Darby, Yeadon, Darby, Lansdowne, Ardmore and Lower Merion. Most requests in the Kensington area are handled the same day when you call early, with dispatch from 7am to 7pm, Sunday through Friday. If you’re outside the immediate area, call and we’ll confirm what’s available before anything is booked.
Serving Kensington, PA – Our Local Coverage Area
We serve Kensington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Repair in Kensington
Chimney repair is fixing the parts of the chimney that have failed, rather than just cleaning it, and it covers the crown, the brick and mortar, the flashing, the liner, and the firebox. It ranges from repointing a few joints all the way up to rebuilding the top of the chimney or relining the flue. In Kensington, most repair calls start with water damage to the masonry or flashing, since our freeze-thaw winters find every weak joint. Call (855) 974-3360 and we’ll tell you what your chimney actually needs after we see it.
Small repairs like repointing, waterproofing or flashing work are usually done in a single visit, often within a few hours. A crown and cap repair or spot brick replacement is also typically same-day. A partial rebuild or a full liner installation can run into two or more days depending on weather and access, and we’ll give you the timeline in the written estimate before any work starts. Call (855) 974-3360 to get your inspection on the schedule.
Typical chimney repair in Kensington runs $250 to $3,500 depending on what’s being repaired, with a partial rebuild or reline at the higher end and repointing or waterproofing at the lower end. The written estimate sets the final price, and the estimate is free with no service-call fee. Nothing gets recommended without camera evidence you can review yourself. Call (855) 974-3360 for an exact quote.
Yes, we service DuraFlex liners and HeatShield flue resurfacing systems along with Famco and Copperfield components. DuraFlex stainless liners are what we use for full relining when the existing flue is too far gone to resurface, and HeatShield is the option when the flue is sound enough to restore from the inside. Which one applies depends on what the camera shows, and we’ll show you the scan before quoting either. Whether you have these or any other make, we can help.
Same-day repair is possible for many common jobs when you call early, though we won’t promise a time before we’ve confirmed it. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside those dispatch hours is booked into the next opening. Call (855) 974-3360 and we’ll confirm what’s available for your chimney.
We stand behind the repair we carry out, and the written estimate spells out exactly what’s covered and for how long before you agree to anything. Material and system warranties come from the manufacturer, so the terms differ between a HeatShield resurfacing and a DuraFlex reline, and we’ll explain which applies to your job. Call (855) 974-3360 and we’ll walk you through it.
Clear the area around the fireplace inside so we can get to the firebox and damper, and move anything fragile away from the hearth. Keep a clear path to the roof access inside the house, and make sure any pets are settled somewhere away from the work area. You don’t need to do anything to the chimney itself; we handle the sweep and prep as part of the visit. Call (855) 974-3360 if you have questions before the appointment.
Schedule Your Chimney Repair Service in Kensington Today
A small mortar crack or a dripping flashing joint is a cheap fix now and a much bigger bill after another freezing winter. Our technicians have up to 9 years of experience on Kensington chimneys, and we’ll show you the evidence before anything is recommended. Call (855) 974-3360. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free and there’s no obligation. See our related chimney cap and crown and chimney liner and rebuild services for the rest of the picture.
Written by the team at Chimney Sweep Kensington.